Hauthane HD-2107 DMM

A hard, NMP-free, APEO-free, aliphatic, polyester-based, aqueous polyurethane dispersion with an exceptional balance of properties.

Suggested Uses: HD-2107 DMM  was designed for topcoat applications on a wide variety of substrates, including concrete, metal, plastic and wood.

Characteristics:

  • Balance of toughness, abrasion- and mar-resistance
  • Outstanding water and chemical resistance
  • Excellent exterior weathering performance
  • Can be crosslinked to enhance performance
  • Dilution and clean-up with ordinary tap water
  • Contains dipropylene glycol dimethyl ether (DMM) co-solvent

Downloads

Hauthane HD-2107 DMM Data Sheet

Physical Properties

Solids
35 %
Solids Tolerance
± 1 %
Viscosity
50 to 300 cps
pH8.5 to 10.0
Density8.7 lb/gal
Softening Point
335 ºF
Volatile Organic Compounds (VOC) Content (As Supplied)
67 g/L
Note for Physical Properties
Provisional - Physical properties are considered provisional until at least 10 production batches have been produced.

Tensile Properties

Elongation
210 %
Tensile Strength
6800 psi
100 % Modulus
4900 psi
200 % Modulus
6750 psi
Note for Tensile Properties
Films are coalesced with 5 % DPM to ensure optimal film formation.
Tested at 20 Inches/Minute

Application

HD-2107 DMM  can be used as a sole vehicle or blended with acrylic emulsions for spray or rotogravure applications. Rheology modifications can be made with associative thickeners for alternative application methods.

Drying

The addition of coalescing solvent is recommended to achieve optimal film formation with HD-2107 DMM. In ambient-cured systems the addition of 5 – 10 % DPnB coalescing solvent is suggested. Less coalescing solvent is required in heat-cured systems to attain comparable film properties. Typical drying temperatures and dwell times for aqueous coatings are sufficient to produce optimal film properties.